InspirationFX: Jack-O-Lantern

Get your creative juices flowing ~ ~ ~

Jack-O-Lantern

Designed by: Erin Singleton

With 3 days to go before Halloween it’s getting pretty hard to tell if your neighbours have been decorating or were the victims of a grizzly murder. In the evening, ghosts sway from tree branches while jack-o-lanterns flicker their orange glow from porch after front porch. To help get in the spirit, without all the cobwebs and caution tape, we’ve come up with this ghoulish necklace.

A Swarovski skull dangles from a strand of matte black river stone while bead caps and bicones mimic the orange fire of the pumpkin. A lacey matte black chain finishes off the necklace. After all, what’s scarier than a bump in the night, than the creek of a hinge and the rattling chains.

To begin the necklace, create the skull drop. Place the skull onto an eyepin and top with a few 3mm bicones or metal rounds. Working part way up your round nose pliers, create a wrapped loop to finish the drop. Make sure to have a good long drop (6mm +) to keep the skull from interfering with the stones. I didn’t think to do this step first and ended up trying to assemble the wrapped loop in place on the finished necklace, making things way more difficult than they needed to be!

Next, layout a pattern of 10mm matte black river stones, interspersed with bead caps and 3mm bicones. On a 1-2 foot length of beading wire, string half of your pattern, then the skull drop, followed by the mirror image of stones and crystals. Using tube crimps and a set of crimping pliers, attach the beaded section of the necklace to either end of an approximately 3 foot length of chain.

To play with the finished length of the necklace, grab the chain at approximately equal distances from the beaded section and bring the two points together at the back of your neck. Try moving the lengths of the two strands around until you are happy with the proportions. Once happy, attach a jumpring to each link at the back of your neck. You may want to count links to ensure the beaded section is centered! Attach a lobster claw to the jumpring on your right (if you’re right handed, or left if you’re a tad sinister) and a chain extender or a length of chain to the opposite jumpring.
For this necklace, I cut about 2 inches of chain off of the 3 foot length, used the main length for the necklace and the 2 inch section as a chain extender.
To add some weight and visual interest to the back of the necklace I used an eyepin and wrapped looped to secure a few bicones and the final bead cap from the package.

 

Components

Go to our components list for this project and to buy what you need!

Need some help with some of the techniques? Check our tips page.

Leave a Reply

Your email address will not be published. Required fields are marked *


By submitting this form, you are consenting to receive marketing emails from: beadFX Inc., 19 Waterman Ave., Unit #2, Toronto, ON, M4B 1Y2, http://www.beadfx.com. You can revoke your consent to receive emails at any time by using the SafeUnsubscribe® link, found at the bottom of every email. Emails are serviced by Constant Contact