(Components list at bottom of page)
by: Rochelle Kilmer
My intention for this piece began as a whole separate concept. This was the end result.
I can't even put into words how many times I put this together and took apart, added components, took some away!!
Although, I can say that the Wire Luxe held up quite nicely. I was able to transform it so many different ways !!
Find the middle of the WireLuxe Wire Ribbon and squeeze it down, compressing it into a smaller size.
Attach a Jumpring to the Key.
Before you close the jumpring, slide it onto the WireLuxe Wire Ribbon, in the center where you squeezed it down. Close the Jumpring.
Slinde one of the Antique Brass Ovals over the WireLuxe on each side of the key.
About every inch twist the WireLuxe .
In between each twist, stretch the WireLuxe out to the sides to get a wavy look.
Centre the Antique Brass Ovals over the Twist on each side of the key.
Squeeze the Ribbon/Leather Ends on the end and attach the jumprings and clasp.
You will have to play with the WireLuxe a bit to get the twists to sit flat.
I hope you enjoy !!!
Clicking on components links will open a new window so that you don't lose this page.
|Home Page||Main Bead Listing||Read our Blog||Email us a question||FAQs||Stay Informed
(join our mailing list)
|Tollfree +1.877.473.BEAD (2323) | +1.416.751.1911|
|Copyright 2017 - BeadFX 2012. All rights reserved|
Your card will be charged in your usual currency based on the rate offered to you by your credit card company.