Note to Self: Do Not Do …

Recently, i was playing with some new stuff – Artist’s Concrete, and I wanted to put it into a mold I had. But the mold did not have a flat bottom, and I knew that it would be tippy, and that I needed to find a way to stabilize it.

Easy peasy – I’ll make a snake of polymer clay, make a ring of it, and push the mold onto it and that will hold it flat and steady while the concrete sets. No problem.

And because I had another thing I was making with the concrete – a ring, which I stabilized in an upright and flat position by cutting a hole for the ring band in a styrofoam meat tray, I put the polymer clay (un-baked) onto the styrofoam tray as well.

So, a week or so later, when I go to clean up (because it is unheard of for me to clean up on the day of!), I discovered this.

The unbaked polymer clay has reacted over time with the styrofoam and make a gooey mess. It ate a channel into the foam, and stuck to the polymer clay, and just thoroughly went icky.

I had to throw both the clay and foam out. No biggie really, but lesson learned. Don’t leave unbaked polymer clay sitting on styrofoam for any length of time.


Leave a Reply

Your email address will not be published. Required fields are marked *

By submitting this form, you are consenting to receive marketing emails from: beadFX Inc., 19 Waterman Ave., Unit #2, Toronto, ON, M4B 1Y2, You can revoke your consent to receive emails at any time by using the SafeUnsubscribe® link, found at the bottom of every email. Emails are serviced by Constant Contact