InspirationFX: Dragonfly Meadows

Dragonfly Meadows

Designed by: Rochelle Kilmer

Blue skies, where the dragonflies fly. Above meadows green, calming and serene.

Sit. Stay for a while and watch the dragons flutter on by.? A light breezes gently moves thru the long grasses; blowing the clouds above. Sweet heat leaving butterfly kisses across your skin. Cicadas making their music, and a gentle hum envelops you.

Be present. Stay in the moment.

Making your necklace:

First I started by making all the separate components, then I laid them out and started piecing the necklace together. Please take full advantage of your artistic license and change or adapt anything you may not like.

On the 22 gauge wire (I kept it on the spool) put on your bead, make a wrapped loop with as little excess wire as possible – before cutting the wire off the spool (with your bead) cut with enough excess wire to make another wrapped loop.? This is how I made all my wrapped loop pieces.

3x turquoise long rectangles
6x olive cream olives
3x dragonfly coin
3x 2/0 3-cut rocailles/poined oval/rocailles

Then I cut about a foot of Softflex. Crimped one end and started stringing on about 6-7 inches of 6/0 seedbeads Ravenswood. Crimp the other end when finished. (This strand I decided was going to break up the wrapped links I made earlier)

I made another strand about 11-12 inches long. (This strand I decided was going to go around the back of the neck)

Back to our wrapped links. I laid them out on the table and placed them into a pattern I liked. I ended up making them into 2 strands with the shorter strand of 6/0’s in between.

1st wrapped link strand – attach using 4mm jumprings –

Olive/long rectangle/olive/dragonfly coin/pointed oval/olive

Attach to short strand of 6/0’s using jumprings.

2nd wrapped link strand – attach using 4mm jumprings –

Long rectangle/dragonfly coin/ olive/pointed oval/olive/dragonfly coin/ long rectangle/olive/pointed oval

Attach to the other end of the short strand of 6/0’s using jumprings.

Now we can attach the longer strand of 6/0’s we made up earlier. Attach using the jumprings.

Where we just attached the jumprings and closed up the necklace, is where we are going to attach the 2 strands of chain.

24 inches of the fine chain and approximately 20 inches of the larger chain.

I choose not to add a clasp because the necklace is large enough to slip over your head. If you prefer a clasp, I would probably choose a decorative toggle and place it on the side where we connected the necklaces.

Now you can go off chasing dragonflies through the meadow.



Go to our components list for this project and to buy what you need!

Need some help with some of the techniques? Check our tips page.

Leave a Reply

Your email address will not be published. Required fields are marked *

By submitting this form, you are consenting to receive marketing emails from: beadFX Inc., 19 Waterman Ave., Unit #2, Toronto, ON, M4B 1Y2, You can revoke your consent to receive emails at any time by using the SafeUnsubscribe® link, found at the bottom of every email. Emails are serviced by Constant Contact