InspirationFX: Pip Jangles

Pip Jangles 

by: Anne Marie Desaulniers

in touch with your inner hippie, with these light and lively “Boho”
inspired earrings. You could even pair them with gauzy tops and
well-worn blue jeans, for a retro-sixties look! This project uses more
of the leftover Pips from my prior two projects (“Pip, Pip, Hooray” – Pendant & Earrings; “Pip The Magic Dragon
– Bracelet), Firepolish crystals, eyepins, Fireline and closed
Jumprings. And I’m not even finished with the Pips yet! Talk about the
bead that keeps on giving!


earrings contain two elements, that when connected, make the 7 dangles
that hang from the loops in the 7-Loop Channel Ear Hoops. The stitched
drop component is attached to an eyepin component; a wrapped loop is
made at the top; which is then attached to the Ear Hoop via a jump ring.

1 – Drop Component:
-Cut a comfortable length of Fireline (I like to cut a generous wingspan’s worth, to start)
needle and then take your needle/Fireline through the following
combination of beads (note, we won’t discuss colours, just the correct
sequence for threading beads on the needle.
-Take your needle/Fireline though the following bead sequence:
-Take your needle/Fireline through the beads a second time to join the drop component
-Pull tight!
-Tie off with a surgeon’s knot.
-Cut Fireline (either by using a Thread Burner, or cutting with scissors)
-You will need to make 7 drops per earring, for a total of 14 drops for the set.
-Follow the sequence shown in the photo below, for colour selection and placement for each of the drops.
colour sequence for the 2nd earring should follow the same pattern as
the first. Of course, if you’re a little bit daring, you could mix up
the colours completely! It’s your choice!

2 – Eyepin Component:
-Open up loop in eyepins (using your pliers – opening it up gently, and to the side).
-Link the open eyepins to the top of your drop component (where the knot is).
the link (again, using your pliers – closing it gently, back to where
you started in the first step – use the reverse of the movement you used
to open it)
-Add the following sequence of items onto your eyepin:
2mmFP/3-4.5mm Closed Jumprings (Nickel)/4mmFP/2mmFP
-Make a small wrapped loop at the top of your eyepin (see “Tips & Tricks” on BeadFX website)
-You will need one eyepin component, for each drop component (7 for each earring, with a total of 14 for the pair).
-Attach each eyepin + drop component to the 7-Channel Ear Hoops with a 5mm jumpring.

Congratulations, your earrings are finished! Now go out and be Boho-fabulous!!!


Go to our components list for this project and to buy what you need!
Need some help with some of the techniques? Check our tips page.

Leave a Reply

Your email address will not be published. Required fields are marked *

By submitting this form, you are consenting to receive marketing emails from: beadFX Inc., 19 Waterman Ave., Unit #2, Toronto, ON, M4B 1Y2, You can revoke your consent to receive emails at any time by using the SafeUnsubscribe® link, found at the bottom of every email. Emails are serviced by Constant Contact