InspirationFX: Pearly White

Pearly White

by: Rochelle Kilmer

It’s getting warm and people are getting married! I have a few friends who are planning on tying the knot over the next couple of years. Such an exciting time in their lives! So I have had weddings on the brain and I needed a creative outlet since it’s not quite yet my turn. And that is how this jewellery set was born. I hope it inspires you as it did me!


Making the links :

On an eyepin place a daisy spacer – coin pearl -daisy spacer. Make a simple loop. I used the 1-step loopers to make things faster (I should probably practice without :p). The loopers may not close your loop all the way, so I just stick my round nose pliers in to close it up nicely.

Repeat this link 3 more times.

On a headpin place 1 White Opal AB bicone. Close with a simple loop. Repeat for the other earring.

I used a 3.5 mm jumpring to attach the bicone to one of the coin pearl links; then I used a 5mm jumpring to attach the top loop of this link to another coin pearl link. On the top loop of this link, I attached it too the earwire. I opened the loop on the earwire as I would a jumring and slipped the link on and closed it up. Repeat for the other earring.


Make 4 more links like you did with the earrings on eyepins: daisy spacer – coin pearl – daisy spacer.

Make 3 links consisting of daisy spacer – bicone – daisy spacer.

Make 2 links with – daisy spacer – bicone – daisy spacer – coin pearl – daisy spacer – bicone – daisy spacer.

Make 1 bicone dangle. Just a bicone on a headpin and finish with a simple loop.

For the pendant: On an eyepin or a headpin: beadcap – a few 10/0 or 11/0 seedbeads, place the becharmed pearl over top (this is so the bighole won’t feel loose and move around on the pin) – bead cap. And this time I finished it with a wrapped loop.

If you wish to add more dangles to the bottom of the pendant use an eyepin. I was not sure if I wanted to or not, so I did the loop and don’t mind the look of it without anything hanging. It’s a preference for you to make. If you do not want to dangle and do not like the look of the loop, make the pendant on a headpin.

Putting it all together:

From the wrapped loop I attached one of the single bicone links using a 5 mm jumpring. Using another jumpring I attached the top loop to the bottom of the nosy posy y link. On the little loop of the nosy posy I added the bicone dangle with a 3mm jumpring.

On one of the top loops of the nosy posy link, I attached one of the coin pearl with bicone link. Then I linked this to a coin pearl link and this linked to a bicone link and this linked to another coin pearl link, all using 5 mm jumprings.

Repeat this on the other loop of the nosy posy link in the same order.

From the open loop I attached chain with 5 mm jumpings on both sides, then attached the nosy posy toggle for the clasp also using 5 mm jumprings.

And a beautiful piece of jewellery is complete.




Go to our components list for this project and to buy what you need!

Need some help with some of the techniques? Check our tips page.

Leave a Reply

Your email address will not be published. Required fields are marked *

By submitting this form, you are consenting to receive marketing emails from: beadFX Inc., 19 Waterman Ave., Unit #2, Toronto, ON, M4B 1Y2, You can revoke your consent to receive emails at any time by using the SafeUnsubscribe® link, found at the bottom of every email. Emails are serviced by Constant Contact